Optical Modules
RoHS-6 Compliant 10 Gb/s 1310nm 10GBASE-LRM X2 Transponder (FTLX1341E2)
The Finisar FTLX1341E2 transponder incorporates Electronic Dispersion Compensation (EDC) which provides correction for the severe modal dispersion that may occur during propagation through links up to 220m on legacy installed FDDI multimode fiber. The EDC device incorporates a Feed Forward Equalizer (FFE) and a Decision Feedback Equalizer (DFE). The EDC also contains sophisticated clock recovery architecture for extracting a robust clock from extremely distorted signals.
- Hot pluggable X2 MSA form factor
- Total power consumption: 4.0 W maximum
- RoHS-6 compliant (lead-free)
- Temperature range 0°C to 70°C
- Transmission distance up to 220m*
- Uncooled 1310nm directly modulated Fabry-Perot (FP) laser
- Built In Advanced Electronic Dispersion Compensation (EDC)
- SC connector, multimode fiber
- Full duplex transmission mode
- Digital Optics Monitoring (DOM)
- Power supply: +5.0 V, +3.3 V
- Adaptable Power Supply (APS: +1.2 V)
- XAUI electrical interface (4 x 3.125 Gb/s)
- Management and control via MDIO 2-wire bus
- 70-pin connector
- Separated signal/chassis ground
- Mid Pak module variance for front panel mounting
- De-latch mechanism with low extraction force
- IEEE 802.3aq-2006
- 10 Gb/s Ethernet transmission on legacy multimode fiber.
* Maximum reach as defined by IEEE. Longer reach possible depending upon link implementation.
- Form Factor
- X2
- Distance
- 220 m
- Protocol
- 10 Gigabit Ethernet Compliant
- Data Rate (max)
- 10.3 Gb/s
- Low End Case Temperature (°C)
- 0°C
- High End Case Temperature (°C)
- 70°C
- Diagnostics
- Digital
- Transmitter
- Fabry-Perot Laser
- Receiver
- PIN
- Voltage Supply
- 1.2
- 3.3
- 5
- Connector
- SC
